CzRobotics G-Lab

Generate spray paths.
Control your machine.

Machine setup Status: Disconnected

Machine profile Sender mode Units

Controller / port

Phase 1

G-code pattern generator

Generate useful starter programs, preview the trajectory, then download the job or continue to supervised machine operation in G-Lab.

Coated area

Width Xmm Length Ymm

Left offsetmm Front offsetmm

Pattern parameters

Line spacingmm Turn radiusauto, mm

Direction Turn mode

Close nozzle during turns Outer contour

Spray and motion

Feed rate mm/min Travel feed mm/min

Safe Zmm Spray Zmm

Nozzle A open A closed

Air command

Layers and timing

Repeats Repeat delays

Header

Machine workspace

Web G-code Sender

These controls physically move the machine. Use carefully.

Checking Web Serial support...

Disconnected

Position

Waiting for GRBL status

X--.-

Y--.-

Z--.-

A--.-

B--.-

C--.-

Run Ready Machine Unknown RX queue 0 / 112 B Accepted 0 / 0

Selected profile setup after homing: G92 X0 Y520 Z0 A0. Z work positions are negative below the upper home point, to approximately Z-120 mm.

Jog controls

Jog step mm Jog feed mm/min

Safety and responsibility

Generated G-code can move a real machine.

Always verify the preview, coordinate origin, Z height, and machine profile before sending.
Only one program may control the USB serial port at a time. Close Candle or UGS before connecting here.
Keep hands, cables, fixtures, and samples clear of the working area.
Use suitable extraction for sprayed materials. Flammable or volatile materials require user-managed safety measures.

Generate spray paths.Control your machine.

G-code pattern generator

Serpentine raster

Web G-code Sender

Position

Jog controls

Program queue

Saved programs

GRBL console

Generated G-code can move a real machine.

Generate spray paths.
Control your machine.